The solar blanket as tiny bubbles that offer insulation for keeping heat. If you have a pool, you might be aware of how much water it can lose through evaporation, especially in the summertime! To suppress this water waste, you can install a swimming pool cover. Not just will a pool cover dramatically decrease evaporation, but it will minimize loss of pool chemicals and reduce energy expenses by assisting to warm and retain heat in the swimming pool water too.
Downside note: Oxygen keeps the chemical balance of water, so your fight against algae might increase. And pool chemicals are difficult on the cover. It's recommended to eliminate the cover for a couple of days following water treatment to permit the swimming pool to "breathe," and minimize the corrosive action of chemicals. If algae run widespread, you can try peeling back the cover so that it only covers half of the swimming pool, rotating to the other end of the swimming pool.
The bubble-wrap-style solar swimming pool blanket is the least expensive type and is meant to keep the heat and water in the pool. Please note that the cover does NOT make the pool more secure for kids or family pets, and always must be taken out before swimming.
Where to Buy the Cover You can purchase a swimming pool solar blanket online from vendors such as Amazon. For about $115 for an 18X36 ft. Width by 12-mil thick swimming pool cover. The cover can have a 7-year service warranty, however, don't anticipate it to last that long. Ultraviolet (UV) radiation, swimming pool chemicals, and standard wear-and-tear are most likely to reduce its life to 3 or 4 years.
Ways to Install the Cover 1. Unfold the cover bubble-side down beside the pool. With an assistant, drag it throughout the surface area of the pool so that it completely covers the pool. For an irregularly shaped swimming pool, simply make sure the cover reaches all the edges when it is pushed down securely where the water meets the boundary liner tile.
2. Use a long-handled swimming pool brush to flatten the cover versus the water, pressing out any large folds or air bubbles. When completely set up, the blanket must drift flat on the water, hardly touching the tile around the border. Following is ways to cut it so that it does that.
3. Cut the blanket where the water fills the tile. To make sure precision, press the cover flat versus the tile up until you can see the waterline along the tile below it. With the sharp knife, cut the lid precisely along the water line.
4. Occasionally check the opposite side of the pool to make sure the cover isn't moving position while you work. Get rid of the excess scraps. hvacsystempros.com
5. When the cover is not in use and during the off-season, it is suggested that you fold it up and save it in a secured place to reduce damage and UV destruction.